URL:
/en-be/go/akb/20020090/1
CAN port, inadvertently connected to 24 V
Question:
Can damage occur at the CAN port of controller 9300 if terminals X4 (system bus…
URL:
/en-be/go/akb/20020065/1
DFRFG, ramp time
Question:
What is the ramp time in the DFRFG if it is only determined by the offset?
Answer:
If the ramp is…
URL:
/en-be/go/akb/20020036/1
Device utilisation C0056, functional description
Question:
What is the significance of device utilisation C0056?
Answer:…
URL:
/en-be/go/akb/20020004/1
Torque increase in the lower speed range during vector control
Question:
How can the torque characteristic in the lower speed range…
URL:
/en-be/go/akb/20010175/1
Feedback system, polarity check
Question:
How can the evaluation of the connected feedback system be examined without any auxiliary…
URL:
/en-be/go/akb/20010174/1
Overload message (OCx) when acceletion in vector controller
Question:
How can overload messages (OCx) be avoided for short…
URL:
/en-be/go/akb/20010173/1
Overload factor of frequency inverter and its influence factors?
Question:
Why can an inverter supply a higher rated current, if…
URL:
/en-be/go/akb/20010172/1
Mains filter, motor filter, sine filter: Temperature sensor function, terminals T1, T2
Question:
What is the purpose of the integrated…
URL:
/en-be/go/akb/20010170/1
Current limit C0599 for motor phase failure monitoring (LP1)
Question:
What are the consequences of the C0599 input parameter…
URL:
/en-be/go/akb/20010168/1
Zero pulses, too many or wrongly detected at X8 or X9
Question:
When an incremental encoder or an absolute encoder with zero track…
URL:
/en-be/go/akb/20010164/1
Interbus with optical fibre
Question:
Can Lenze Interbus communication modules (AIF, FIF) be connected with an Interbus, which…
URL:
/en-be/go/akb/20010163/1
Vector control in case of 8200vector/motec, steps of commissioning
Question:
Which motor data must be entered for the control mode…
URL:
/en-be/go/akb/20010162/1
Lightness and Contrast adjustments applied to keypads (HMI)
Question:
How can the contrast and the brightness be applied to keypads…
URL:
/en-be/go/akb/20010161/1
Set value poti on 100 %, the default results in only half of the output frequency
Question:
Why does the 8200 / 8200 vector / motec…