Current full version of the Drive PLC Developer Studio Basic V2.4 inclusive Service Pack 1

Description

The software development environment for the PLC of the drive. The 9300 Servo PLC and Drive PLC are programmed using the Drive PLC Developer Studio (DDS) integrated software development environment.

System requirements

• Microsoft® XP 32 Bit as of SP3 / Windows® 7 / Windows® 8
• IBM-compatible PC with Intel® Pentium® processor as of 333 MHz
• 128 MB RAM
• 250 MB free hard disk capacity
• Minimum resolution of 1024 x 768 pixels with 256 displayable colours
• Mouse
• Free slots / interfaces according to the requirements of the fieldbus interface module to be used

Notes

With the installation routine you can execute the following installations:

• full verison DDS Basic V2.4 (input of a licence number is necessary) 
• update DDS Basic from V2.x to V2.4 (installation of a previous DDS version is necessary)

Information on function extensions and fault eliminations are provided in the following difference descriptions:

• Difference description of Drive PLC Developer Studio from V2.3 SP3 to V2.4
• Difference description of Drive PLC Developer Studio from V2.4 to V2.4 SP1.

Please observe the function restriction: Using the parameter monitor leads to program crash

The full functional range of the Drive PLC Developer Studio Basic can be used free of charge. During installation, the license number specified under 'Software Installation' (point 2) must be entered.

Software installation
Depending on the current status of your PC there are two different ways to execute the installation: 

1. Previous version V2.4 is installed: Installation of Service Pack 1
   Proceed as follows to install the Service Pack for DDS Basic V2.4: 
   1. Save the file DDS_V24SP1.zip (64.2 MB) in any directory on your PC.
   2. Unpack the ZIP file into any directory on your PC.
   3. Close all DSD versions if you have already started them. 
   4. Start the setup.exe file and follow the installation instructions.
2. In all other cases
   Proceed as follows to install the full version of DDS Basic V2.4:
   1. Save the file DDS_Basic_V24a.zip (67.9 MB) in any directory on your PC. 
   2. Unpack the ZIP file ino any directory on your PC.
   3. Close all DSD versions if you have already started them.
   4. Start the setup.exe progam and follow the installation instructions.
   5. Enter the following license number: 87654072 
      Install the current Service Pack afterwards:
   6. Save the file DDS_V24SP1.zip (64.2 MB) in any directory on your PC. 
   7. Unpack the ZIP file into any directory on your PC.
   8. Close all DSD versions if you have already started them.
   9. Start the setup.exe file and follow the installation instructions.
   10. Check, if you can extend the Drive PLC Developer Studio with the latest device data update by new device-specific files for Lenze target system.