Corrected from:
EASY Starter V1.14
Response of the new version:
When saving a parameter set as a gdc file, the decimal places of 'FLOAT_64' parameters are not truncated.
After saving the parameter set of a controller as a gdc file, the decimal places of some parameters differ when comparing the parameter set of the GDC file and the online device.
When does this behaviour occur?
When saving a parameter set as a gdc file, the decimal places of 'FLOAT_64' parameters are truncated. The parameters are FAST Motion parameters.
Which products are affected?
EASY Starter V1.10 SP2 and higher
Short-term measures:
None
Evaluation/recommendations:
Use the online help and check which FAST Motion parameters are 'FLOAT_64' parameters. Observe that the decimal places of these parameter values are truncated when the parameter set is saved as a gdc file.
