TA SyncAndCorrection: Switching the SystembusOut to "Corrected Set Value" does not work (fixed from V01.03.07)

​Fiexd:
Servo-Inverter i950 (from V01.03.07)
Behaviour of the new version:
When parameter 0x5020:001 is switched to value 5 (Corrected Master Values), the marker-corrected conductance values are copied to the output of the system bus.
 
Description of the behaviour:
Epectation:
When parameter 0x5020:001 is switched to value 5 (Corrected Master Values), the marker-corrected conductance values are copied to the output of the system bus.
The switchover does not work.  The system bus output remains permanently at the last value copied before switching over.
 
Under what conditions does the behaviour occur?
-
 
Affected products:
Servo-Inverter i950 TA SyncAndCorrection
Automatic Translation

URL for linking this AKB article: https://www.lenze.com/en-de/go/akb/201900116/1/
Meta data
Taxonomy: TA i900
AKB-ID: 201900116
Last update: 2023/09/09
Category: Version Informations

Lenze reserves the right to change information on this page at any time. Any liability for the accuracy of the information is excluded.
Contact form