TA Electronic Gearbox: The 10th system bus participant does not receive any process data (fixed from V1.9.1)

Fixed from:

Servo inverter i950 (from V01.09.01)

Behavior of the new version:

All system bus slaves receive the same setpoints via the system bus.

Description of the behavior:

In a topology with more than 9 system bus devices, the 10th device does not receive any master values (cycle length, position, speed, acceleration) via the system bus.

Affected products:
Servo Inverter i950

Short-term measure, recommendations, evaluation:

Lifted from:

i950 Firmware V1.9.1.

Behavior of the new version:

All system bus slaves receive the same set values via the system bus.

Description of behavior:

Conditions under which the behavior occurs:
In a topology with more than 9 system bus nodes, the 10th node does not receive any control values (clock length, clock rate, etc.). In a topology with more than 9 system bus participants, the 10th participant does not receive any control values (cycle length, position, speed, acceleration) via the system bus.

Affected products:
i950 firmware <V1.9.1

Short-term measures, Recommendations, Rating:
-

[Automatic Translation]

URL for linking this AKB article: https://www.lenze.com/en-de/go/akb/202300436/1/