Setting of the wrong 'Default setpoint source'

Corrected from:

EASY Starter V1.26

Behavior of the new version:

The problem has been solved. The correct parameter is displayed again.

Description of the behavior:
The EASY Starter displays the wrong parameter for the 'Default setpoint source' in the overview dialog on the Settings tab. The tooltip of the 'Default setpoint source' shows the wrong parameter.

Conditions under which the behavior occurs
The behavior described above occurs when using EASY Starter 1.25.1 for setting the 'Default setpoint source' of an i4xx, i5xx or i6xx inverter in the overview dialog on the Setting tab.

The shown 'Default setpoint source' depends on operation mode 0x6060:000.

Affected products:
EASY Starter from V1.25.1

All i4xx, i5xx and i6xx inverter incl. protec and motec.

Short-term measure, recommendations, evaluation:

Depending on parameter 0x6060:000 ('Operation mode') set the default setpoint source in the 'Parameter list' tab:

0x6060:000 = "MS: Torque mode [-1]" → 0x2860:003
0x6060:000 <> "MS: Torque mode [-1]" → 0x2860:001

Use older versions V1.25 or V1.24.

URL for linking this AKB article: https://www.lenze.com/en-de/go/akb/202400108/1/