URL:
/en-de/go/akb/201000858/1
Default document for safe parameter setting SM301
Question: Does there exist a default document in which the safe parameters can be…
URL:
/en-de/go/akb/201000890/1
Maximum permissible input frequency of encoder feedback system - maximum number of encoder increments
Question:
What is the maximum…
URL:
/en-de/go/akb/201000912/1
Multi Drive 9400 installation backplane - cable cross-section of PE connection
Question:
Which cable cross-section is required for…
URL:
/en-de/go/akb/200703482/1
Isolation transformer/generator - dimensioning for the supply of inverter drives
Question: For which power do you have to dimension an…
URL:
/en-de/go/akb/200911457/1
Communication path Profinet with L-force «Engineer» PC software
Question:
How can you use the L-force «Engineer» via a Profinet…
URL:
/en-de/go/akb/200910500/1
Parallel operation of two asynchronous motors on a 9400 HighLine in servo control mode
Question:
Is it possible to operate two…
URL:
/en-de/go/akb/200909249/1
Simulating the REF-OK signal (9300Ex) on the 9400 HighLine controller series
Question:
For the 9300Ex servo controller series,…
URL:
/en-de/go/akb/200909377/1
On-board CAN - no communication CAN Run LED off
Question:
Why can communication not be established although the CAN line is…
URL:
/en-de/go/akb/200902130/1
Status signal DI_bMainSupplyOk remains at LOW level
Question:
Why does the status signal DI_bMainSupplyOk at system block…
URL:
/en-de/go/akb/200907357/1
CAN on-board remains in ¨Initialisation¨ status (C0359 = 8 = CAN-Init) after power-on
Question:
Why do controllers of the 9400 series…
URL:
/en-de/go/akb/200902151/1
Error message ¨1.2.102 Selected control system could not be opened¨ when connecting ETCMMI with ETC
Question:
Why do I get the error…
URL:
/en-de/go/akb/200907312/1
Non-volatile storing of user-defined codes without giving the command C0002 = 11 (¨save start parameters¨)
Question:
Is it possible…
URL:
/en-de/go/akb/200907306/1
Non-volatile storing of a counter value (L_TbCount)
Question:
Is it possible to store the counter output of the function block…
URL:
/en-de/go/akb/200603295/1
Complete duplication of parameter set and cam data on a 9300EK cam profiler (parameter transfer e. g. when exchanging the…