URL:
/en-de/go/akb/200801673/1
Using axis data in different tasks
Question:
9400 HighLine servo controllers provide different tasks (two interval tasks and one…
URL:
/en-de/go/akb/200901612/1
Safety characteristics of the SU100
Question: My machine must be approved according to ISO 13849-1 or IEC 61508. What are the safety…
URL:
/en-de/go/akb/200905108/1
Acceptance protocol for SM100 - Initial commissioning
Question: Is there a form available for an acceptance protocol for drive-based…
URL:
/en-de/go/akb/200905110/1
Acceptance protocol for SU100 - Initial commissioning
Question: Is there a form available for an acceptance protocol for drive-based…
URL:
/en-de/go/akb/200904672/1
Motor-encoder combinations released for safe speed and position detection
Question: Which motor-encoder combinations have been…
URL:
/en-de/go/akb/200801805/1
Persistent variables - declaration
Question:
How can you create PERSISTENT variables?
Answer:
The Servo PLC (as of V6.3) and…
URL:
/en-de/go/akb/200801728/1
Loss of recipe data
Question:
Why is the recipe data deleted with some Lenze operating units when the operating units are switched…
URL:
/en-de/go/akb/200800787/1
Leakage current of inverter drive 8400 (0.25...45.0 kW) BaseLine, StateLine, HighLine, TopLine, motec
Question: What are the leakage…
URL:
/en-de/go/akb/200904409/1
8200 vector - enclosure for device variant push-through technique
Question:
Which enclosure do the 8200vector devices have in the…
URL:
/en-de/go/akb/200903230/1
Table positioning - Options for target position selection
Question:
Which target position selection options are available for table…
URL:
/en-de/go/akb/200802639/1
9400 with SM100 - Safe torque off with PM-switching safety PLC - performance level e
Function: When the safety function is requested,…
URL:
/en-de/go/akb/200802499/1
PDO Transfer with EL100
Question: Is it possible to send and receive PDOs from the visualisation using the EL100? Answer: Yes, see…
URL:
/en-de/go/akb/200903711/1
Minimum speed setting at the analog input
Question:
How can a minimum speed be set for the inverter drives 8400 in the same way as…
URL:
/en-de/go/akb/200901018/1
Motor parameters required for third-party motors
Question: Which motor parameters are required to use specific motor control functions…
URL:
/en-de/go/akb/200901859/1
Status of CAN axis synchronisation using the UserLED
Question:
How can the status of drive synchronisation via CAN sync be seen from…