URL:
/en-de/go/akb/201304158/1
¨Autoconfig Master/Slave¨ option of EtherCAT master
What happens?
Due to a configuration error, the EtherCAT master does not change to…
URL:
/en-de/go/akb/201304169/1
i700 and I/O 1000 bus coupler parameters are not updated
What happens?
The parameters of the i700 servo inverter and the I/O 1000…
URL:
/en-de/go/akb/201304173/1
Mapping an ¨Array of byte¨ to an existing array does not work
What happens?
The process image mapped into a variable does not correspond…
URL:
/en-de/go/akb/201303110/1
L-force Motion: L_SMC_TouchProbe_FASTIO: Incorrect position value after executing 'MC_SetPosition' with an external encoder (no correction…
URL:
/en-de/go/akb/201303101/1
Conversion of the CanOpen configuration causes compilation errors
Which products are affected?
PLC Designer from V3.5
What happens?…
URL:
/en-de/go/akb/201303091/1
PLC Designer cannot log off
Which products are affected?
PLC Designer from V3.5
What happens?
In the PLC Designer, a log off from the…
URL:
/en-de/go/akb/201303086/1
Updating an i700 V1.2.x.x does not transfer a complete mapping
Which products are affected?
PLC Designer from V3.5
Servo Inverter i700…
URL:
/en-de/go/akb/201303056/1
Speed limitation values of the i700 cannot be changed via the process image
Which products are affected?
PLC Designer from V3.5
What…
URL:
/en-de/go/akb/201303414/1
PLC Designer does not start (corrected from V2.6.3)
Corrected from: PLC Designer V2.6.3L-force Engineer V2.20 Response of the new…
URL:
/en-de/go/akb/201205349/1
Incorrect conversion into application units of the LS_DisFree_a
Which products are affected?
StateLine with firmware version…
URL:
/en-de/go/akb/201205347/1
The comparator block (L_Copare_3) cannot be integrated
Which products are affected?
StateLine with firmware version V11.00
What…
URL:
/en-de/go/akb/201303275/1
Error message when calling the German online help
What happens?
When calling the German online help, an error message occurs, e. g.
-…
URL:
/en-de/go/akb/201301794/1
Target position is overrun due to too low jerk setting
What happens?
The programmed target position is overrun.
When does the problem…
URL:
/en-de/go/akb/201301277/1
Ck13 warning signal in the case of positioning modes > 3 at the FB L_MckCtrl interface (eliminated from firmware HighLine V6.2/V11.2 and…