URL:
/en-de/go/akb/200801934/1
CAN-AUX interface is not supported by L_ParRead/L_ParWrite (remedied from B-SW V8.0)
Remedied from:
ECS axis module V8.0
Behaviour…
URL:
/en-de/go/akb/200801933/1
Codes for synchronising the drive are missing in the keypad menu (remedied from B-SW V8.0)
Remedied from:
ECS axis module V8.0
Not…
URL:
/en-de/go/akb/200801932/1
Display bit of the CANaux state ¨BusOff¨ cannot be reset (remedied from B-SW V8.0)
Remedied from:
ECS axis module V8.0
Behaviour of…
URL:
/en-de/go/akb/200801914/1
CAN2 and CAN3 are not sent sync controlled
Remedied from:
ECS axis module operating software V8.0
EVS93xxEI (Servo PLC from V8.0)…
URL:
/en-de/go/akb/200801910/1
Data of the sync telegram too long (elimination)
Remedied from:
ECS axis module V8.0
EVS93xx-EI (Servo PLC V8.0)
EVS93xx-ET (Servo…
URL:
/en-de/go/akb/200800120/1
Incorrect status signal of the function block L_CamSetXAxisVelocity with negative master value (elimination)
Which products are affected?…
URL:
/en-de/go/akb/200800119/1
Setting the auxiliary integrator via the L_CamControl.bLoadAux input (elimination)
Which products are affected?
ESP-SPAC-CAM1 – Cam V2.0…
URL:
/en-de/go/akb/200800118/1
Incorrect relative positioning following an aborted relative positioning run on the function block L_CamPosCtrlLin (elimination)
Which…
URL:
/en-de/go/akb/200800117/1
Vibration at the function block output L_CamPosCtrlLin.dnPosOut_p (elimination)
Which products are affected?
ESP-SPAC-CAM1 – Cam V2.0…
URL:
/en-de/go/akb/200800115/1
Incorrect speed acceptance with the function block L_CamVMasterPosition in single cycle mode (elimination)
Which products are affected?…
URL:
/en-de/go/akb/200801309/1
Saving the project when it has been opened via the quick start guide (elimination)
Which products are affected?
Engineer HighLine V2.5…