URL:
/es-es/go/akb/200606042/1
Absolute position of Hiperface encoders (elimination)
Which products are affected?
EVS93xx-EI (Servo PLC V7.0)
EVS93xx-ET (Servo PLC…
URL:
/es-es/go/akb/200606041/1
CAN telegrams are no longer received (elimination)
Which products are affected?
EVS93xx-EI (Servo PLC V7.0)
EVS93xx-ET (Servo PLC V7.0…
URL:
/es-es/go/akb/200606040/1
Keypad indicates a wrong value for analog outputs (elimination)
Which products are affected?
EVS93xx-EI (Servo PLC V7.0)
EVS93xx-ET…
URL:
/es-es/go/akb/200606039/1
Retain variables are not saved in a mode protecting against mains failure (elimination)
Which products are affected?
EVS93xx-EI (Servo…
URL:
/es-es/go/akb/200606037/1
Error messages of the Fail-QSP type are stored in the fault memory with a wrong offset (elimination)
Which products are affected?…
URL:
/es-es/go/akb/200606036/1
C0856 by factor 10000 too large (elimination)
Which products are affected?
EVS93xx-EI (Servo PLC V7.0)
EVS93xx-ET (Servo PLC V7.0 with…
URL:
/es-es/go/akb/200606034/1
Torque limit in case of quick stop (QSP) (elimination)
Which products are affected?
EVS93xx-EI (Servo PLC V7.0)
EVS93xx-ET (Servo PLC…
URL:
/es-es/go/akb/200605988/1
Elapsed-hour meter (C0178) and power-on time meter (C0179) exhibit deviation of 20 s/h (eliminated in ECS OPERATING SYSTEM as of V8.3,…
URL:
/es-es/go/akb/200605811/1
Acceleration step when the profile is changed over and in case of S-ramps (elimination)
Which products are affected?
ESP-SPAC-POS1 –…
URL:
/es-es/go/akb/200605813/1
The following error is not accepted when the home position is set (elimination)
Which products are affected?
ESP-SPAC-POS1 – Software…
URL:
/es-es/go/akb/200605815/1
Control functions via visualisation elements (elimination)
Which products are affected?
ESP-SPAC-POS1 – Software Package Positioner V4.0…
URL:
/es-es/go/akb/200605109/1
Installation setup: Wrong designation in the English dialog for selecting the components while installing the update (remedied from…
URL:
/es-es/go/akb/200605080/1
Installation setup may crash if the PC has a FAT partition (remedied from DDS V2.3 SP2, GDC V4.10, DriveServer V1.3.1, CamDesigner V2.3.4,…